Table of Contents
Advertisement
7. Position the tape in the alignment groove of the leader pin attach tool (see 1
in Figure 15).
8. Place a new C-clip into the retention groove 2 (Figure 15) on the leader pin
attachment tool and make sure that the clip's open side faces up.
9. Place the leader pin (from step 6 on page 24) into the cavity 3 (Figure 15) of
the leader pin attach tool.
Attention: To prevent the leader pin from rolling into the cartridge, in the
following step use care when folding the tape over the pin.
10. Fold the tape over the leader pin and hold it with your fingers (see Figure 15).
Note: Use care to ensure that the tape is centered over the leader pin. Failure
to properly center the tape on the pin will cause the repaired cartridge
to fail. When the tape is properly centered, a 0.25-mm (0.01-in.) gap
exists on both sides of the pin.
1
5
Figure 15. Attaching the leader pin to the tape
11. Close the pivot arm 4 of the leader pin attach tool by swinging it over the
leader pin so that the C-clip snaps onto the pin and the tape.
12. Swing the pivot arm open and trim the excess tape 5 so that it is flush with
the reattached leader pin 6 .
2
3
6
4
Chapter 3. Using the media
25
Advertisement
Table of Contents
