Function Code A: Clear Error Code Log; Function Code C: Insert Cartridge Into Tape Drive; Function Code E: Test Cartridge & Media - IBM TS3310 Maintenance Information

2. Press the Unload Button once per second until
cycle past the desired code, press the Unload Button once per second until the
code reappears.)
3. Press and hold the Unload Button for three or more seconds, then release it to
view the most recent error code.
4. Press the Unload Button again to view successive error codes. Let two to three
seconds pass between each depression. The SCD will display
error codes have been displayed.
5. After viewing all error codes, exit this function by pressing the Unload Button
again. The SCD will display

Function Code A: Clear Error Code Log

Function Code
1. Place the drive in Maintenance Mode. For instructions, see "Entering
Maintenance Mode" on page D-27.
2. Press the Unload Button once per second until
cycle past the desired code, press the Unload Button once per second until the
code reappears.)
3. Press and hold the Unload Button for three or more seconds, then release it to
select the function.
erases all errors from the error code log and exits Maintenance Mode.

Function Code C: Insert Cartridge into Tape Drive

This function cannot be selected by itself, but is part of other maintenance
functions (such as Run Tape Drive Diagnostics and Create FMR Tape) that require
a tape cartridge to be inserted.
Function Code E: Test Cartridge & Media
Approximate Run Time = 15 minutes per loop
Total Number of Loops = 10
Function Code
its magnetic tape are acceptable.
Press the Unload Button to stop the diagnostic and exit maintenance mode.
Pressing the Unload Button once will abort the test at the end of the current test
loop. Pressing the Unload Button twice will abort the test immediately. Wait for the
drive to rewind the tape and unload the cartridge.
Attention: When you perform this test, data on the suspect tape will be
overwritten.
0
and exit Maintenance Mode.
A
erases the contents of the error code log.
A
flashes in the SCD, followed by
E
performs tests that determine whether a suspect cartridge and
9
appears in the SCD. (If you
0
when all the
A
appears in the SCD. (If you
0
. The tape drive
Appendix D. Using Ultrium Drives
D-35