Programming Jumpers; Light Flash (+); Activation Input (+) - Avital 4003 Installation Manual

Programming jumpers

ACTIVATION INPUT POLARITY
TACH THRESHOLD
LIGHT FLASH OUTPUT

➢ Light flash (+)/(-)

This jumper is used to determine the light flash output polarity. In the (+)
position, the on-board relay is enabled and the unit will output (+)12V
on the WHITE wire, H1/9. In the (-) position, the on-board relay is dis-
abled. The WHITE wire, H1/9, will supply a 200mA (-) output suitable
for driving factory parking light relays
Note:
For parking light circuits that draw 10 amps or more, the internal
jumper must be switched to a (-) light flash output.
standard automotive SPDT relay must be used on the H1/9 light flash
output harness wire.

➢ Activation Input (+)/(-)

This jumper is used to determine the input polarity to activate the remote
start. In the (+) position the White/Blue H1/4 wire will require a (+)
pulse to activate the remote start. In the (-) position the White/Blue
H1/4 wire will require a (-) pulse to activate the remote start.
20
Input polarity jumper
(-)
(+)
*
*
O
On
(-)
(+)
*
*default setting
AVISTART 4003
© 2009 Directed Electronics. All rights reserved.
P/N 8617
or a