Avital 4003 Installation Manual page 37

8 2nd STATUS OUTPUT—
grammed to status mode, this output turns on when the remote start is
activated. It can be programmed as a Latched or Pulsed output, and
can be used to activate the rear defroster when the vehicle is remote
started. When programmed to the latched output the status stays ac-
tive for 10 minutes. When programmed to the pulsed output the status
sends out a single pulse. When programmed for the latched or pulsed
mode the output activates 10 seconds after the remote start is running.
9 ANTI-GRIND
locked output will be active during remote start operation. This activates
an optional relay and prevents the customer from re-cranking the car
with the key, when doing key takeover. If accessories such as a voice
module or window module are added to the unit, it may be necessary
to use the two-honk setting to program this feature OFF.
10 WAIT-TO-START TIME
wait-to-start timer default is in the OFF setting. When programmed ON
the onboard timer can be set for 15, 30 or 45 seconds.
11 RUN TIME (TIMER MODE) * 3, 6, 9, 12 MINUTES: Selects the
time in minutes that the system operates the engine before timing out.
12 minutes is the maximum system operation time. The system may be
shutdown at any time.
Important:
only when adding a receiver (P/N 543H) and re-
mote P/N 474L).
© 2009 Directed Electronics. All rights reserved.
ON
:*With the anti-grind On (default) the ground-when-
OFF
Features with an asterisk (*) are available
NORMAL
/LATCHED/PULSED: If pro-
/15, 30, 45 SECONDS: The diesel
33