➢ Door lock harness, 3-pin connector*
1
BLUE
2
EMPTY
3
GREEN
*Available only when adding a receiver (P/N 543H) and remote
(P/N 474L).
➢ Remote start harness (H2) wiring diagram
H2/1
BLACK/WHITE
H2/2
VIOLET/WHITE
H2/3
BROWN
H2/4
GRAY
H2/5
BLUE/WHITE
Primary harness (H1), 9-pin connector
H1/1
LIGHT GREEN/
BLACK
This wire sends a negative pulse every time the remote start is activated
or the doors are unlocked. This can be used to pulse the disarm wire
of the vehicle's factory anti-theft device. Use a relay to send a (-) or (+)
pulse to the disarm wire as shown in the following diagrams.
8
(-) UNLOCK OUTPUT
NOT USED
(-) LOCK OUTPUT
(-) NEUTRAL SAFETY SWITCH INPUT
TACHOMETER INPUT WIRE
(+) BRAKE SWITCH SHUTDOWN WIRE
(-) HOOD PINSWITCH SHUTDOWN WIRE
(-) 200mA 2ND STATUS/REAR DEFOGGER OUTPUT
(-) FACTORY ALARM DISARM
© 2009 Directed Electronics. All rights reserved.