Avital 4003 Installation Manual page 36

12
2 RUN TIME— /24/60 MINUTES: This feature controls how long the
engine will run before it "times out" and shuts down. Programmed to the
default setting the engine will run for 12 minutes. If the 24 or 60 minute
run time is desired, change this feature to the two or three flash setting.
CONSTANT
3 PARkING LIGHTS— /FLASHING: In the default setting,
the parking lights will come on solidly for the entire run duration. The
flashing setting - the parking lights flash for the entire run duration.
0.6
4 CRANk TIME— /0.8/1.0/1.2/1.4/1.6/1.8/2.0/4.0 Sec-
onds: If the feature is programmed to the voltage sense setting, the
crank time must be set to the appropriate duration. The default setting
is 0.6 second. If a different crank time is desired, press the transmitter
button to advance through the LED Off settings. The unit flashes the
LED to indicate which time is selected. Once the 4.0 second setting is
reached the next pulse resets the system to the shortest setting.
1
5 ACTIVATION PULSE COUNT— /2/3 PULSES: This feature allows
the number of pulses to activate the remote start feature to be changed
from 1, 2, or 3 pulses. The pulse count programmed to start the vehicle
will also be the same required to shut down the remote start.
IGNITION
6 2nd— /ACCESSORY OUTPUT: This will allow the PINk/
WHITE to be used as a 2 ignition or a 2 accessory.
nd nd
OFF
7 ACCESSORY STATE DURING WAIT-TO-START— /ON: This will
allow the programming of the accessory wire during the wait-to-start
period of a diesel motor. When ON the accessory comes on when the
wait-to-start timer is activated and stays on, dropping out during crank
and returning once the car has started. When OFF the accessory will
activate as a normal accessory.
32
© 2009 Directed Electronics. All rights reserved.