Avital 4003 Installation Manual page 41

3. Test the NEUTRAL SAFETY shutdown circuit:
Important:
the front and rear of the vehicle before attempting this
test.
a. Make sure the hood is closed and no other shutdown circuits are
active.
b. Set the emergency brake.
c. Turn the ignition key to the run position but do not start the en-
gine.
d. Put the vehicle in Drive (D).
e. Put your foot over the brake pedal but do not press down on it. Be
ready to step on the brake to shutdown the remote start system.
f. Activate the remote start system.
• If the starter engages, immediately step on the brake to shut down
the system. If it does engage, recheck the neutral safety input con-
nection. The vehicle may use a mechanical neutral safety switch.
(See H2/1 BLACk/WHITE neutral safety switch input in Remote
Start Harness Wire Connection Guide section of this guide.)
• If the starter does not engage, the test is complete.
Once the system passes all three tests, the vehicle can be re-assembled
and delivered. Do not use the remote start system or finalize the instal-
lation if it fails any of the safety check tests.
© 2009 Directed Electronics. All rights reserved.
Make sure there is adequate clearance to
37