Avital 4003 Installation Manual page 14

H1/2 GREEN/WHITE
This wire sends a negative pulse every time the remote start shuts down
or the doors are locked. This can be used to pulse the arm wire of the
vehicle's factory anti-theft device. Use a relay to send a (-) or (+) pulse
to the arm wire.
H1/3 YELLOW
The H1/3 YELLOW wire is connected to the ignition input of the host
security or keyless entry system.
Disconnect the ignition/accessory input of the remote controlled secu-
rity or keyless entry system. Connect the H1/3 YELLOW ignition output
to the ignition/accessory input of the remote controlled security or key-
less entry system. The wire will prevent the host system from sensing that
the ignition is on during remote start operation.
H1/4 WHITE/BLUE
This input comes from the factory set to 1 activation pulse. This means
that it is necessary to have 1 positive or ground pulse (see the Pro-
gramming jumper section of this guide) on the white/blue wire for the
remote start to activate or to deactivate. This wire will be connected to
a security or keyless entry system.
Note:
The activation pulse count can be programmed to 1, 2, or 3
pulses.
10
(-) FACTORY ALARM REARM
(+) IGNITION OUT (TO ALARM)
(+/-) ACTIVATION INPUT
© 2009 Directed Electronics. All rights reserved.