Menu 2 - Avital 4003 Installation Manual

ON
10 PANIC
any time from the remote and will sound for 30 seconds. When off the
panic feature does not function.

➢ Menu 2

Important:
only when adding a receiver (P/N 543H) and re-
mote P/N 474L).
1 ENGINE CHECk VIRTUAL TACH (1): When set to "virtual tach" (1)
the remote start monitors the cranking voltage of the vehicle and sets it
as a reference point. Fifteen seconds after the crank output sequence
the remote start checks the voltage again to determine if the vehicle is
running.
When set to voltage, (2) the unit cranks the starter for the programmed
time and then attempts to sense that the engine is running by detecting
an increase in voltage. If programmed Off (3) the vehicle cranks for
the programmed crank time. The tach setting or voltage setting is not
checked to verify that the car is running. In the OFF setting, if the vehicle
fails to start, the ignition stays on for the run duration. Using tach or
either of the voltage settings is recommended. When set to Tachometer,
(4) the unit references the learned tach signal to disengage the starter.
In addition it will monitor the RPM and shut down if the engine RPM is
too high or too low.
© 2009 Directed Electronics. All rights reserved.
/Off*: When on, the panic feature can be activated at
Features with an asterisk (*) are available
31