Table of Contents
Advertisement
Installing hardware options
Installing optional trays
CAUTION—SHOCK HAZARD: If you are accessing the controller board or installing optional
hardware or memory devices sometime after setting up the printer, then turn the printer off, and unplug
the power cord from the electrical outlet before continuing. If you have any other devices attached to the
printer, then turn them off as well, and unplug any cables going into the printer.
1. Turn off the printer using the power switch, and then unplug the power cord from the electrical outlet.
2. Unpack the tray, and then remove any packing material.
3. Remove the tray from the base.
4. Remove any packing material from inside the tray.
5. Insert the tray into the base.
6. Place the tray near the printer.
User's Guide
- 25 -
Advertisement
Table of Contents
