Installation Points To Remember - Clifford Responder LE 3.3X Installation Manual

Installation points to remember

This product is designed for fuel-injected, automatic transmission, or vehicles
with manual transmissions.
Note: The default option "Manual" is a safety precaution that forces the installer
to enable the Manual Transmission Mode (MTS) routine or program the unit to the
"Automatic" option before the remote start can be activated for the first time.
The "Automatic" option will need to be programmed On to work with automatic
transmissions. When the "Manual" option is selected a specific routine is re-
quired before exiting the vehicle to enable the MTS mode.
Before beginning the installation
Please read this entire installation guide before beginning the installation.

The installation of this remote start system requires interfacing with many of the
vehicle's systems. Many new vehicles use low-voltage or multiplexed systems that
can be damaged by low resistance testing devices, such as test lights and logic
probes (computer safe test lights). Test all circuits with a high quality digital
multi-meter before making connections.
 Do not disconnect the battery if the vehicle has an anti-theft-coded radio.
If equipped with an air bag, avoid disconnecting the battery if possible. Many
airbag systems will display a diagnostic code through their warning lights after
they lose power. Disconnecting the battery requires this code to be erased, which
can require a trip to the dealer.
If using an external LED or Valet Switch, check with the customer about where

to locate the switch.
 To avoid accidental battery drainage; turn off the interior lights or remove
the dome light fuse.
Roll down a window to avoid being locked out of the car.


© 2008 Directed Electronics—all rights reserved