Table of Contents
Advertisement
H1/11 WHITE Parking light output
This wire should be connected to the parking light wire in the vehicle. See Setting
the light flash polarity section of this guide for polarity settings.
(+) Positive Light Flash Output
11
(-) Negative Light Flash Output
11
Note: For parking light circuits that draw 10 amps or more, the internal jumper
must be switched to a (-) light flash output. (See Setting the light flash polarity
section of this guide.) P/N 8617 or a standard automotive SPDT relay must be
used on the H1/2 light flash output harness wire.
H1/12 ORANGE (-) ground-when-armed output
This wire supplies a (-)500 mA ground as long as the system is armed. This out-
put ceases as soon as the system is disarmed. The GWA can be hooked up to a
window control module, a voice module or any accessory that requires a ground
when armed.
2
© 2008 Directed Electronics—all rights reserved
Hide quick links:
Advertisement
Table of Contents
