Table of Contents
Advertisement
H1/9 BLACK/WHITE (-) 200 mA dome light supervision output
Connect this wire to the optional dome light supervision relay as shown below:
Important! This output is only intended to drive a relay. It cannot be connected
directly to the dome light circuit, as the output cannot support the current draw
of one or more light bulbs.
H1/10 WHITE/BLUE Remote start turbo timer (-) activation input
This input comes from the factory set to 1 activation pulse. This means that it is
necessary to have a single ground pulse on the white/blue wire for the remote
start to activate or to deactivate. This wire can also be used to activate the Turbo
Timer mode when the car is running and this wire receives a ground.
Note: The number of activation inputs can be programmed to 1 or 2 pulses with
an optional momentary switch This setting affects both the input wire and the
remote control when operating the remote starter.
2
To white/blue activation
input on system
© 2008 Directed Electronics—all rights reserved
Hide quick links:
Advertisement
Table of Contents
