Clifford Responder LE 3.3X Installation Manual page 31

H2/4 VIOLET/BLACK 200 mA (-) programmable Aux 2 output
This wire provides 200 mA programmable output whenever the transmitter but-
tons controlling Aux 2 channel is pressed. (See descriptions for Aux 3.)
Warning! Never use this wire to drive anything but a relay or a low-cur-
rent input! This transistorized output can only supply 200 mA. Connecting
directly to a solenoid, motor, or other high-current device will cause the
module to fail.
H2/5 WHITE/BLACK 200 mA (-) programmable Aux 3 output
This wire provides 200 mA programmable output whenever the transmitter button
(s) controlling Aux 3 is pressed. This output can be programmed to provide the
following types of outputs
Validity: Output that sends a signal as long as the transmission is received.
■
Latched: Output that sends a signal when the Aux channel button is pressed
■
and continues until the same button is pressed.
Latched, reset with ignition: Similar to the latched output, this type of out-
■
put turns On the first time the Aux channel button is pressed, and turns Off the
next time the same button is pressed. This type of output additionally stops and
resets whenever the ignition is turned On and then Off.
30 seconds timed: The output sends a continuous signal for 30 seconds.
■
Note: Bitwriter® programs from 1 to 90 seconds.
Warning! Never use this wire to drive anything but a relay or a low-cur-
rent input! This transistorized output can only supply 200 mA. Connecting
directly to a solenoid, motor, or other high-current device will cause the
module to fail.
© 2008 Directed Electronics—all rights reserved
31