Clifford Responder LE 3.3X Installation Manual page 72

3-2 ENGINE CHECKING VIRTUAL TACH: (1) When set to "virtual tach" the re-
mote start will monitor the cranking voltage of the vehicle and set that voltage
as a reference point. Fifteen seconds after the crank output sequence the remote
start checks the voltage again to determine if the vehicle is running.
When set to voltage, the unit cranks the starter for the programmed time and
then attempts to sense that the engine is running by detecting an increase in
voltage. When set to Tachometer, the unit references the learned tach signal to
disengage the starter. In addition it will monitor the RPM and shut down if the
engine RPM is too high or too low.
Note: The tach wire must be connected and programmed for the manual trans-
mission mode to work.
3-3 CRANK TIME 0.6 0.8 (2) 1.0 (3) 1.2 (4) 1.4 (5) 1.6 (6) 1.8 (7) 2.0 (8) 4.0
(9) SECONDS: If the unit is programmed for no engine checking or voltage sense,
the crank time must be set to the appropriate duration. The default setting is 0.6
second and the LED will flash once. If a different crank time is desired, toggle
through the higher settings by using the two-chirp settings.
Note: The numbers in parentheses indicate the number of times the LED will
flash.
3-4 RUN TIME 12 (1), 24 (2) 60 (3) MINUTES:
Selects the time in minutes
that the system will operate the engine until the system "times out". The system
may be shut down using the remote or any of the shutdowns at any time. Using
the Bitwriter®, the run time can be programmed for any duration from 1-60
minutes.
3-5 ACTIVATION PULSE ONE: This allows the system to use 1 or 2 pulses to acti-
vate the remote start sequence. The default setting is 1-pulse.
Note: This setting affects both the input wire and the remote control.
3-6 TURBO MODE: OFF The factory default is OFF. ON - 1 min (2), 3 (3) 5 (4) 10
(5) MINUTES: There are two ways that "turbo timer mode" can be activated, one
by remote and the other manually.
To activate by remote the vehicle needs to be running. Press the button
on the remote two times and then press the remote start button. When you
receive a confirmation tone on the remote you can turn off the ignition, and the
car will remain running.
2
© 2008 Directed Electronics—all rights reserved