Clifford Responder LE 3.3X Installation Manual page 7

After the remote start module has been installed, test the remote start

module in accordance with the Safety Check outlined in this installation
guide. If the vehicle starts when performing the Neutral Safety Shutdown
Circuit test, the remote start unit has not been properly installed. The remote
start module must be removed or properly reinstalled so that the vehicle
does not start in gear. All installations must be performed by an authorized
Directed Electronics dealer. OPERATION OF THE REMOTE START MODULE IF THE
VEHICLE STARTS IN GEAR IS CONTRARY TO ITS INTENDED MODE OF OPERATION.
OPERATING THE REMOTE START SYSTEM UNDER THESE CONDITIONS MAY RESULT
IN PROPERTY DAMAGE OR PERSONAL INJURY. IMMEDIATELY CEASE THE USE
OF THE UNIT AND REPAIR OR DISCONNECT THE INSTALLED REMOTE START
MODULE. DIRECTED ELECTRONICS, INC. WILL NOT BE HELD RESPONSIBLE OR
PAY FOR INSTALLATION OR REINSTALLATION COSTS.
Remote starters for manual transmission pose significant risks if not

properly installed and operated. When testing to ensure the installation is
working properly, only remote start the vehicle in neutral gear, on a flat surface
and with a functional, fully engaged parking brake. Do not allow anyone to stand
in front of or behind the vehicle.
This product should NOT be installed in any convertible vehicles, soft or hard

top. Installation in such vehicles may pose certain risk.
© 2008 Directed Electronics—all rights reserved