System Features Learn Routine - Clifford Responder LE 3.3X Installation Manual

System features learn routine

The System Features Learn Routine dictates how the unit operates. It is possible
to access and change any of the feature settings using the Valet/program switch.
However, this process can be simplified by using the Bitwriter®. Any of the
settings can be changed and then assigned to one of four remote controls. This
feature is called Owner Recognition. Each time that particular remote control is
used to disarm the system, the assigned feature settings will be recalled. Owner
Recognition is only possible when programming the unit via the Bitwriter®.
If programming with the Bitwriter®, the learn routine can be locked or
unlocked. If the learn routine has previously been locked, it must be
unlocked with Bitwriter® - this cannot be done manually with the Valet
switch.
switch. (The Valet/Program switch must be plugged into the blue port.) After
three seconds the siren will chirp once indicating entry to the Basic Features
Menu. If this is the menu you want, release the button and go on to Step 4. If
the button is not released, the program jumps to the next menu and the siren
chirps twice. There are three possible menus. Once you have selected the menu
you want, release the Valet/Program switch.
0
1. Open a door. (The GREEN wire, H1/8, or the VIOLET,
H1/6 must be connected.)
2. Ignition. Turn the ignition on, then off. (The heavy
gauge PINK wire must be connected.)
3. Select a Menu. Press and HOLD the Valet/Program
© 2008 Directed Electronics—all rights reserved