Clifford Responder LE 3.3X Installation Manual page 71

Responder le security and remote start
Hide thumbs Also See for Responder LE 3.3X:
Table of Contents

Advertisement

2-10 Channel 1 Linking, None (1) Arm (2) Disarm (3) Arm/Disarm (4) Remote
Start (5). When programming to Validity or timed output this can be programmed
to activate when arming or disarming (or remote start) with the transmitter.
2-11 Channel 2 Validity (1) Latched (2), Latch reset w/ignition (3), 30-sec.
timed, (4) Output, (5) Off: Channel 2 can be programmed for these output con-
figurations. The unit is set to the default validity output. To change the configu-
ration use the two-chirp setting to toggle through the different configurations.
Refer to feature 2-9 for additional details.
2-12 CHANNEL 2 Linking None (1) Arm (2) Disarm (3) Arm/Disarm (4) Remote
Start (5). Refer to feature 2-10 for additional details.
2-13 CHANNEL 3 Validity (1) Latched (2), Latch reset w/ignition (3), 30 -sec.
timed, (4) Output, (5) Off: Channel 3 can be programmed for these output con-
figurations. The unit is set to the default validity output. To change the configu-
ration use the two-chirp setting to toggle through the different configurations.
Refer to feature 2-9 for additional details.
2-14 CHANNEL 3 Linking None (1) Arm (2) Disarm (3) Arm/Disarm (4) Smart
key control (link to remote start Off) (5). When channel 3 is programmed to
Smart Key control, this wire outputs a 800ms pulse when the remote start is
shut off.
The alarm also monitors the door trigger input so when the door is opened dur-
ing the remote start runtime, the remote start shuts down and this wire outputs
the 800ms pulse.
Note: This wire is connected to the wire at the push button that start/stops the
car. It pulses the wire at the button to shut off the car when the remote start is
deactivated.
Menu 3 - Remote start options
Default settings are in bold.
3-1 MANUAL TRANSMISSION MODE: This is the default setting. The two-chirp
setting is used for Automatic transmission mode. In the default setting the
remote start unit is programmed to look for a shutdown procedure to activate
the remote start.
1
© 2008 Directed Electronics—all rights reserved

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents