Outputs For Optional External Remote Start Relays - Clifford Responder LE 3.3X Installation Manual

Outputs for optional ext. remote start relays
These signals are provided to drive additonal optional relays.
(-) 200mA Flex Relay Control Output
PINK/WHITE
This wire is programmed as (-) 2nd ignition output from factory and can be pro-
grammed (to drive a relay) as a (-) starter or accessory output.
(-) 200mA Accessory output
ORANGE
This wire works like the main accessory wire and can be used (with a relay) to
drive any additional accessory circuits in the vehicle.
(-) 200mA Starter output
VIOLET
This wire works like the starter wire and can be used (with a relay) to drive any
additional starter circuits in the vehicle.
(-) 200mA ignition 1 output
PINK
This wire works like the ignition 1 wire and can be used (with a relay) to drive
any additional ignition circuits in the vehicle.
Note: Wires 1 - 4 on the remote start auxiliary outputs are wired to the (-)
triggers for the onboard remote start relays and are not diode isolated. If wir-
ing these wires directly to the vehicle you must place a 1-amp diode in line to
prevent feedback from the vehicle.
BLUE (-) 200mA status output
This wire supplies an output as soon as the module begins the remote start pro-
cess. It can be used to activate a bypass module or power the key sense wire in
most vehicles to disarm the factory alarm without unlocking.
Note: Check vehicle information to verify if a bypass module is needed or if the
key sense wire is needed.
© 2008 Directed Electronics—all rights reserved
4