Table of Contents
Advertisement
H3/8 PINK/BLACK – 87a of Ignition 2/Flex relay.
This wire is used when an ignition switch isolation on the vehicle is necessary.
This is common on Toyota and Nissans which required the use of Tech Tip docu-
ment #1077. (See menu # 3 Feature 8 for programming options)
H3/9 RED/BLACK –
This wire is the polarity feed to the accessory and starter relays.
Remote start input - 5-pin connector
Neutral safety switch input
BLACK/WHITE
Connect this wire to a ground source if installing this unit in an automatic trans-
mission vehicle. If this unit is being installed in a manual transmission vehicle
then connect it to the emergency brake wire. This input MUST rest at ground in
order for the remote start system to operate.
Important! Always perform the steps outlined in Safety Check section to verify
that the vehicle cannot be started in ANY drive gear and that the override switch
is functioning properly.
Tachometer input
VIOLET/WHITE
This input provides the module with information about the engine's revolutions
per minute (RPMs). It can be connected to the negative side of the coil in ve-
hicles with conventional coils. In multi-coil and high energy ignition systems
locating a proper signal may be more difficult. (See Finding the Wires You Need
section of this guide.) Once connected, you must teach the system the tach
signal.
Note: This wire MUST be used when installing this unit on a manual transmis-
sion.
© 2008 Directed Electronics—all rights reserved
30a fused accessory/starter relay input
4
Hide quick links:
Advertisement
Table of Contents
