Alcatel-Lucent OmniSwitch 6800 Series Management Manual page 37

Managing System Files
Note. Your login account must have write privileges to use the
Certified Directory
(Files)
In this first example, the user's current directory is the flash directory. The following command syntax
moves the testfile2 file from the user created testfiles directory into the working directory as shown in the
illustration above. The screen displays a warning that the file is being renamed (or in this case, redirected).
-> move /flash/testfiles/testfile2 /flash/working/testfile2
WARNING:renaming file /flash/testfiles/testfile2 -> /flash/working/testfile2
In the next example, the user's current directory is the /flash/testfiles directory as shown in the
illustration, so it is not necessary to specify a path for the file being copied. However, the command syntax
specifies a path to the destination directory. The screen displays a warning that the file is being renamed.
-> move testfile2 /flash/working/newtestfile2
WARNING:renaming file /flash/working/newtestfile2 -> /flash/working/newtestfile2
In this third example, the user's current directory is the flash directory. Here, it is not necessary to specify
a path for the destination file but a path must be specified for the original file. The screen displays a
warning that the file is being renamed.
-> move /flash/testfiles/testfile2 newfile2
WARNING: renaming file /flash/testfiles/testfile2 -> /flash/testfiles/newfile2
In each of the above examples, a new file will be written to the specified or assumed path with the new
filename. In each case, the file being copied will be removed from its original location.
OmniSwitch 6800/6850/9000 Switch Management Guide
Flash Directory
Working Directory
(Files)
File and Directory Management
move or mv command.
Network Directory
(File)
policy.cfg
December 2007
Testfiles Directory
(File)
testfile2
page 1-17