Changing The Https Port - Alcatel-Lucent OmniSwitch 6800 Series Management Manual

WebView CLI Commands
As an alternative you can use the https keyword instead of the http keyword to enable Force SSL. For
example:
-> https ssl
When using this format of the command use the no https server command to disable Force SSL on the
switch.

Changing the HTTPS Port

The default secure HTTP (HTTPS) port is 443, the well-known port number for SSL. You can change the
port to a number in the range 0 to 65535 using the
which are in the range 0 to 1023, cannot be configured.)
Note. All WebView sessions must be terminated before the switch accepts the command.
For example:
-> https port 2500
This command changes the secure HTTP port to 2500.
To restore an HTTPS port to its default value, use the default keyword as shown below:
-> https port default
page 9-4
https port
OmniSwitch 6800/6850/9000 Switch Management Guide
command. (Well-known port numbers,
Using WebView
December 2007