Alcatel-Lucent OmniSwitch 6800 Series Management Manual page 223

Using WebView
Modifying an Existing Entry
To modify an existing entry:
1 Click on the checkbox to the left of the entry on the Configuration page and click Modify. The Modify
window appears (e.g., Modify IP Static Route). The current configuration is displayed in each field.
2 Modify the applicable field(s), then click Apply. If successful, the Modify window disappears. The
new configuration takes effect immediately and the modified entry appears in the table. If there is an error,
the window will remain and an error message is displayed.
3 Repeat the procedure to modify additional entries.
Deleting an Existing Entry
To delete an existing entry:
1
Click on the checkbox to the left of the entry on the Configuration page.
2 Click Delete. The entry is immediately deleted from the table.
Note. You can delete multiple entries by selecting the checkbox next to each entry. Click on the top box to
select all entries in the table.
OmniSwitch 6800/6850/9000 Switch Management Guide
Modify Window
December 2007
Configuring the Switch With WebView
page 9-13