Alcatel-Lucent OmniSwitch 6800 Series Management Manual page 246

Hide thumbs Also See for OmniSwitch 6800 Series:
Table of Contents

Advertisement

SNMP Overview
No. Trap Name
22
dvmrpNeighborLoss
dvmrpInterfaceLocalAddress—The IP address this system will use as a source address on this interface. On
unnumbered interfaces, it must be the same value as dvmrpInterfaceLocalAddress for some interfaces on the
system.
dvmrpNeighborState—State of the neighbor adjacency.
23
dvmrpNeighborNotPruning
dvmrpInterfaceLocalAddress—The IP address this system will use as a source address on this interface. On
unnumbered interfaces, it must be the same value as dvmrpInterfaceLocalAddress for some interfaces on the
system.
dvmrpNeighborCapabilities—This object describes the neighboring router's capabilities. The leaf bit indi-
cates that the neighbor has only one interface with neighbors. The prune bit indicates that the neighbor supports
pruning. The generationID bit indicates that the neighbor sends its generationID in Probe messages. The mtrace
bit indicates that the neighbor can handle mtrace requests.
page 10-16
Objects
dvmrpInterface-
LocalAddress
dvmrpNeigh-
borState
dvmrpInterface-
LocalAddress
dvmrpNeigh-
borCapabili-
ties
OmniSwitch 6800/6850/9000 Switch Management Guide
Family
Description
ipmr
A 2-way adjacency relationship
with a neighbor has been lost.
This trap is generated when the
neighbor state changes from
"active" to "one-way," "ignor-
ing" or "down." The trap is sent
only when the switch has no
other neighbors on the same
interface with a lower IP address
than itself.
ipmr
A non-pruning neighbor has been
detected in an implementation-
dependent manner. This trap is
generated at most once per gen-
eration ID of the neighbor. For
example, it should be generated
at the time a neighbor is first
heard from if the prune bit is not
set. It should also be generated if
the local system has the ability to
tell that a neighbor which sets the
prune bit is not pruning any
branches over an extended period
of time. The trap should be gen-
erated if the router has no other
neighbors on the same interface
with a lower IP address than
itself.
Using SNMP
December 2007

Advertisement

Table of Contents
loading

This manual is also suitable for:

Omniswitch 6850 seriesOmniswitch 9000 series

Table of Contents