Alcatel-Lucent OmniSwitch 6800 Series Management Manual page 254

Hide thumbs Also See for OmniSwitch 6800 Series:
Table of Contents

Advertisement

SNMP Overview
No. Trap Name
57
alaStackMgrOutOfTokensTrap
alaStackMgrSlotNINumber—Numbers allocated for the stack NIs as follows:
- 0: invalid slot number
- 1..8: valid and assigned slot numbers corresponding to values from the entPhysicalTable
- 1001..1008: switches operating in pass through mode
- 255: unassigned slot number.
Note: This trap is not supported on OmniSwitch 9000 switches.
58
alaStackMgrOutOfPassThruSlotsTrap N/A
Note: This trap is not supported on OmniSwitch 9000 switches in the current release.
59
gmHwVlanRuleTableOverloadAlert
gmOverloadRuleTable—Overloaded hardware VLAN rule table.
gmOverloadRuleType—VLAN rule types that are not configured due to the overload of the hardware VLAN
rule table.
gmOverloadRuleVlanId—The overloaded VLAN ID.
gmOverloadRuleMacAddress—The overloaded MAC address.
gmOverloadRuleIpAddress—The overloaded IP address.
gmOverloadRuleProtocol—The overloaded protocol type.
gmOverloadRuleIpxNetwork—The overloaded IPX network address.
60
lnkaggAggUp
traplnkaggId—
Index value of the Link Aggregate group.
traplnkaggIfIndex
page 10-24
Objects
alaStack-
gmOverloadRu-
gmOverloadRu-
gmOverloadRu-
gmOverloadRu-
gmOverloadRu-
gmOverloadRu-
gmOverloadRu-
traplnkaggId
traplnkaggPor-
—Port of the Link Aggregate group.
OmniSwitch 6800/6850/9000 Switch Management Guide
Family
chassis
MgrSlotNI-
Number
chassis
vlan
leTable
leType
leVlanId
leMacAd-
dress
leIpAddress
leProtocol
leIpxNetwork
linkaggre-
gation
tIfIndex
Using SNMP
Description
The element identified by
alaStackMgrSlotNINumber will
enter the pass through mode
because there are no tokens
available to be assigned to this
element.
There are no pass through slots
available to be assigned to an ele-
ment that is supposed to enter the
pass through mode.
An overload trap occurs when-
ever a new entry to the hardware
VLAN rule table gets dropped
due to the overload of the table.
Indicates the link aggregate is
active. This trap is sent when any
one port of the link aggregate
group goes into the attached
state.
December 2007

Advertisement

Table of Contents
loading

This manual is also suitable for:

Omniswitch 6850 seriesOmniswitch 9000 series

Table of Contents