Alcatel-Lucent OmniSwitch 6800 Series Management Manual page 256

SNMP Overview
No. Trap Name
67 alaVrrp3TrapProtoError
alaVrrp3TrapProtoErrReason
68 alaVrrp3TrapNewMaster
alaVrrp3OperMasterlpAddrType
alaVrrp3OperMasterlpAddr
the Ip address listed as the source in the advertisement last received by this virtual switch. For IPv6, a link
local address.
alaVrrp3TrapNewMasterReason
69 gmHwMixModeSubnetRuleTable-
OverloadAlert
gmSubnetRuleTable
gmOverloadRuleSlice
Note: This trap is not supported on OmniSwitch 6800/6850/9000 switches in the current release.
page 10-26
Objects
alaVrrp3TrapPr
—This indicates the reason for protocol error trap
alaVrrp3OperM
alaVrrp3OperM
alaVrrp3TrapNe
—This specifies the type of alaVrrp3OperMasterlpAddr in this row
—The master switch's real (primary for vrrp over IPv4) IP address. This is
—This indicates the reason for NewMaster trap.
gmSubnetRule-
gmOverloadRu-
—Overloaded HW subnet rule table.
—Overloaded slot Id.
OmniSwitch 6800/6850/9000 Switch Management Guide
Family
vrrp
otoErrReason
vrrp
asterlpAd-
drType
asterlpAddr
wMasterRea-
son
vlan
Table
leSlice
Using SNMP
Description
The error trap indicates that the
sending agent has encountered
the protocol error.
.
The newMaster trap indicates
that the sending agent has transi-
tioned to Master state.
An subnet overload trap occurs
in mixed mode whenever a new
entry to the HW subnet rule table
gets dropped due to the overload
of the table.
December 2007
.