Non-Hot-Plug Components - Fujitsu PRIMERGY RX300 S6 Operating Manual

Non-hot-plug components

I
The new fans are measured with explicit commands in Server
Management. Depending on the result, the corresponding LED (see
figure 34 on page
flashing (failure) or orange lighting (prefailure).
Ê Return the housing cover to its position (see
housing" on page
8.2 Non-hot-plug components
V
CAUTION!
The actions described in this section may only be performed by
personnel with the appropriate technical training. (The device can be
seriously damaged if it is opened without authorization or if repairs
are attempted by untrained personnel.)
Before installing/removing memory to/from the server, turn off the
server, all peripheral devices, and any other connected devices. Al s o
unplug all power cables from the outlet. Failure to do so can cause
electric shock.
The circuit boards and soldered parts of internal options are exposed
and can be damaged by static electricity. Before handling them, first
touch a metal part on the server to discharge static electricity from
your body.
Do not touch the circuitry on boards and soldered parts. Hold the
metallic areas or the edge of the circuit boards.
Do not install unauthorized third party memory modules. Doing so
may cause electric shock, a fire, or failures.
Wait for a sufficient period of time after server shutdown before
installing or removing memory modules. Failure to do so may cause
burns. When installing or removing memory modules, make sure to
remove the screws at the specified points only. Failure to do so may
cause injury. It may also cause failures.
Touch only the specified part of the printed circuit board. Failure to do
so may cause injury. It may also cause failures.
Do not insert and remove memory modules repeatedly. Doing so may
cause failures.
112
110) is set to dark (fan is in order) or orange
119).
Operating manual
section "Opening/closing the
RX 300 S6