Non-Hot-Plug Components - Fujitsu PRIMERGY RX300 S5 Operating Manual

Non-hot-plug components

8.2 Non-hot-plug components
V
CAUTION!
The actions described in this section may only be performed by
personnel with the appropriate technical training. (The device can be
seriously damaged if it is opened without authorization or if repairs are
attempted by untrained personnel.)
Please observe the safety information in
on page 27.
If a defective non-hot-plug component is detected (further information can be
found in chapter "Starting up and operation" on page 59
ServerView Suite Local Service Concept - LSC" manual on the PRIMERGY
ServerView Suite DVD 2), proceed as follows:
Ê Exit all applications and shut down the server properly (see section
"Switching the server on and off" on page
Ê Unplug all power plugs.
Ê Open the server (see section
Ê Press the Indicate CSS button on the system board (see the technical
manual for the system board D2619).
The PRIMERGY Diagnostic LED of the defective CSS component lights up
orange, thereby indicating which CSS component (memory module or
expansion card) on the system board must be replaced (see technical
manual for the system board D2619).
100
chapter "Important information"
71).
"Opening/closing the housing" on page
Operating manual
CSS components
and the "PRIMERGY
106).
RX300 S5