Non-Hot-Plug Components - Fujitsu PRIMERGY TX150 S7 Operating Manual

Non-hot-plug components

8.2 Non-hot-plug components
V
CAUTION!
The actions described in this section may only be performed by
●
personnel with the appropriate technical training. (The device can be
seriously damaged if it is opened without authorization or if repairs
are attempted by untrained personnel.)
Before installing/removing memory to/from the server, turn off the
●
server, all peripheral devices, and any other connected devices. Also
unplug all power cables from the outlet. Failure to do so can cause
electric shock.
The circuit boards and soldered parts of internal options are exposed
●
and can be damaged by static electricity. Before handling them, first
touch a metal part on the server to discharge static electricity from
your body.
Do not touch the circuitry on boards and soldered parts. Hold the
●
metallic areas or the edge of the circuit boards.
Do not install unauthorized third party memory modules. Doing so
●
may cause electric shock, a fire, or failures.
Wait for a sufficient period of time after server shutdown before
●
installing or removing memory modules. Failure to do so may cause
burns. When installing or removing memory modules, make sure to
remove the screws at the specified points only. Failure to do so may
cause injury. It may also cause failures.
Touch only the specified part of the printed circuit board. Failure to do
●
so may cause injury. It may also cause failures.
Do not insert and remove memory modules repeatedly. Doing so may
●
cause failures.
If the memory module has not been correctly inserted, it may cause
●
a fire. Insert the memory module with attention to its direction.
If a memory module is installed and you pull the Lever strongly
●
outwards, the memory module pops up. Doing so may cause a device
failure.
Please observe the safety information in
●
information" on page
102
27.
Operating Manual
CSS components
chapter "Important
TX150 S7