Fujitsu PRIMERGY RX300 S6 Operating Manual page 99

40.5 - 57 DC power supply
Figure 27: Unlocking and removing the power supply unit
Ê Push the green catch in the direction of the arrow (1) while pulling the power
supply unit out of its mounting location (2) by the handle.
I
Grip the handle while pulling the power supply. Do not pull the power
supply by the green catch. If you pull the green catch, the green catch
may come off.
Ê Slide the new power supply unit into the empty slot until it clicks into place.
I
Make sure that the power supply unit engagescorrectly in the s lot and
is locked in position.
This is the only way to prevent the power supply unit from sliding out
of its mountings and being damaged during transportation.
Ê Connect the newly installed power supply unit with the power source.
RX300 S6
Operating manual
Hot-plug components
99