Fujitsu PRIMERGY RX300 S6 Operating Manual page 62

Connecting devices to the server
Three additional USB connectors (1) are located on the front of the server
(figure 15):
Figure 15: Front side: additional USB connectors
I
If components with large power requirements (e.g. external USB hard
disk drives) are connected simultaneously, these USB connectors may
be switched off.
Connecting the keyboard, mouse and monitor
Ê Connect the monitor, keyboard and mouse to the standard connectors of the
server (see table and
I
If a separate graphics card is installed in a slot, the graphic controller on
the system board is automatically deactivated. The corresponding video
connector (VGA) can not be used. Plug the data cable of the monitor into
the video connector of the graphics card.
Ê Connect the power cable of the monitor to the mains socket strip of the rack.
V
CAUTION!
The rated current for the monitor is indicated on the technical data label
on the monitor or in the operating manual for the monitor.
62
figure 13 on page
Operating manual
1 1 1
60).
RX 300 S6