4.4
Connecting the server to the power source
In its basic configuration level the server has a hot-plug power supply unit.
A second hot-plug power supply unit can be added to ensure a redundant power
supply. If one power supply unit is defective, the other then guarantees
unimpaired operation. Each hot-plug power supply unit can be replaced during
operation (see
"Hot-plug power supply units" on page
V
CAUTION!
The server is automatically set to a mains voltage in the range 100 V -
240 V. You may only operate the server if its rated voltage range
corresponds to the local mains voltage.
For the RX300 S6 CG variant the server is automatically set to a mains
voltage in the range 40.5 V - 57 V. You may only operate the server if its
rated voltage range corresponds to the local mains voltage.
4.4.1
RX300 S6 to the mains
4.4.1.1
Connecting the power cord
Figure 16: Connecting the server to the mains
Ê Connect the power cable with the insulated connector to the power supply
unit of the server, and plug the power plug into a grounded outlet on the
mains socket strip on the rack (see Technical Manual of the rack).
RX300 S6
Connecting the server to the power source
Operating manual
96).
63