Fujitsu PRIMERGY RX300 S6 Operating Manual page 19

Further information on other SAS/SATA RAID controllers (e.g. for
operating external SAS/SATA hard disk drives or tape drives) is available
on ServerView Suite DVD 2 under Industry Standard Servers - Expansion
Cards - Storage Adapters - LSI RAID / SCSI Controllers.
Accessible drives/components
A number of mounting locations are available:
– One 3.5-inch slimline bay for an optional Local Service Module:
ServerView Local Service Display (LSD) or
ServerView Local Service Panel (LSP)
– One 3.5-inch slimline bay for an optional optical drive
For a configuration with 3.5-inch HDD modules, an optional DAT or RDX drive
can be installed in the right-hand drive cage. This means that the top two bays
of the drive cage are occupied and are no longer available for HDD modules.
For the configuration with 8*2.5-inch HDD modules, an optional 3.5-inch DAT or
RDX drive can be installed next to the right-hand drive cage.
I
The accessible drives/components described in this section cannot be
replaced during operation.
USB connector (external)
Three USB connectors on the front of the device support activities carried out
by the service technician. The maximum length of the external cable is two
meters for the USB connectors on the front.
Another four USB connectors are available on the rear of the device.
USB connectors (internal)
Additional USB connectors are available on the system board: one is for an
optional DAT drive or an optional RDX drive. Other connector can be used for
either a UFM or a USB stick.
RX300 S6
Operating manual
Features
19