Fujitsu PRIMERGY RX300 S6 Operating Manual page 75

LAN indicators
Figure 23: Indicators on the connection panel: LAN indicators
1 LAN
link/transfer
(service LAN)
2 LAN speed
(service LAN)
3 LAN
link/transfer
(system LAN)
4 LAN speed
(system LAN)
I
Depending on the settings in the BIOS, the standard LAN connector 1
may also be used as a service LAN connector. You will find further
information in the "D2619-N15 BIOS Setup Utility for PRIMERGY
RX300 S6 and TX300 S6" manual.
RX300 S6
Steady green signal when a LAN connection exists.
Remains dark when no LAN connection exists.
Flashes green when LAN transfer takes place.
Steady green signal in the event of a LAN transfer rate
of 100 Mbit/s.
Remains dark in the event of a LAN transfer rate of
10 Mbit/s.
Steady green signal when a LAN connection exists.
Remains dark when no LAN connection exists.
Flashes green when LAN transfer takes place.
Steady yellow signal in the event of a LAN transfer rate
of 1 Gbit/s
Steady green signal in the event of a LAN transfer rate
of 100 Mbit/s.
Remains dark in the event of a LAN transfer rate of
10 Mbit/s.
Operating manual
Controls and indicators
1 2 3 4 3 4
75