Automatically Changing Paper Paths On Paper Out - AMT Datasouth documax 3300 User Manual

User's Guide

3.11 Automatically Changing Paper Paths On Paper Out

The printer may be configured to automatically change paper paths during a paper out
condition.
After changing paths, the printer will attempt a load. If paper is found, printing will continue.
If no paper is installed, the unit will stop and indicate a paper out condition.
To enable this feature:
1. Open Keypad Door.
2. Press the Next Menu key until Menu 4 is displayed.
3. Press Feature
4. Press Value
5. Close Keypad Door and press the Profile key to save profile.
3-26 Forms Handling
This may be useful in applications where the
printer is unattended or installed at a remote
location. If this feature is enabled, the same
forms must be loaded in both paper paths.
M4 PRINTER CNTRL
until feature is displayed.
Auto Path SW Off
to turn the feature on, and then press the Enter key to save selection.
NOTE