AMT Datasouth documax 3300 User Manual page 160

User's Guide
Menu 10: System Control
Displayed Function
Reset Quick List
Add Quick FTR
Delete Quick FTR
Ribbon Life
Replace Rib
Check Rib
Config
D-4 System Administration Features
Values
Resets the list of features accessed by the Quick
Access key to the default features.
Use Value
Access key. Press Enter key.
This feature can now be accessed using Quick Access
key. Up to seven features can be available with the
Quick Access key.
Use Value
Quick Access key. Press Enter key.
This feature will no longer be accessible from the
Quick Access key.
1- 50M The value in this feature indicated the total number of
characters (in millions) that the RIBBON USED
feature uses to calculate the percent ribbon used.
1 to 100 This value indicates when the printer displays the
REPLACE RIBBON message. This feature
monitors the Ribbon Used feature and must be set
to a value greater that the CHECK RIB feature.
1 to 100 This value indicated when the printer displays the
CHECK RIBBON message. This feature must be
set to a value less that the REPLACE RIB feature.
This feature monitors the Ribbon Used feature.
Tractor Sets the mechanical configuration of the printer.
Trac-Fric This is set to the correct value at the factory.
Dual Trac This feature is useful if the firmware or main
electronics controller board is replaced.
Trac Roll The value is automatically saved.
Description of Features
keys to select feature to add to Quick
keys to select feature to delete to