User's Guide
Symptom
Printer Will Not Switch Paths
First Print Line Location is
Wrong
Print Contrast on Last Sheet
is Too Light
Printer is Too Noisy
5-22 Troubleshooting and Maintenance
Corrective Action
Change the Path Value to "Either" under M2: Forms
Control. (See Section 3.8 – 3.13).
Verify the Config feature in M10 matches the
configuration of the printer.
Readjust the first print line using the instructions in
Section 3.4.
Verify the forms thickness setting is correct for the form
being used.
Enable the High Impact feature under M4: Printer Control
(See Section 4.6 – 4.7)
Select an NLQ font listed in Section 3.4.
Enable Quiet Mode feature under the M8: Form
Thickness Control. (See Section 4.6 – 4.7).