9
148
Install adapter pins (83 30 2
152 841) 1 in the rear wheel
swinging arm on left and right
and tighten to the specified
z
torque.
Adapter to rear wheel
swinging arm
20 Nm
Turn brackets 2 long ends out.
Adjust adapters 3 to the width
of the pins inserted in the rear
wheel swinging arm.
Set the height of the rear-
wheel stand to raise the rear
wheel slightly clear of the
ground.
Engage the rear-wheel stand in
the rear wheel swinging arm
and apply even pressure to
push it down to the ground.
Bulbs
Replacing low-beam and
high-beam headlight bulb
The plug arrangement can
differ from the illustration,
depending on the bulb to be
replaced.
Make sure the ground is level
and firm and place the motor-
cycle on its stand.