BMW HP4 Rider's Manual page 46

SLICK
mode 4 as an extra se-
4
lectable item.
Installing coding plug (
44
z
The SLICK mode is set up
for racing slicks and the as-
sumption on which the parameter
settings are based is that tyre-
to-surface grip is of the very high
level generally encountered only
on race tracks.
Activate SLICK mode only on
race tracks and only when run-
ning the motorcycle on racing
slicks.
In RACE and in SLICK
mode, there is an increased
risk of rollover because the rear
45).
wheel lift-off protection system
is switched off. In SLICK mode,
there is an additional risk of ac-
cident because the ABS control
on the rear wheel is turned off in
case only the foot brake pedal is
applied.
Be prepared during hard breaking
for the rear wheels to lift up off
the road surface.
Repeatedly press button 1 until
the arrow is to the left of the
setting you want.
With the motorcycle at a stand-
still, the mode you select is
activated immediately.
The newly selected riding
mode is activated as you
ride only when the following
preconditions are satisfied:
Brake not applied
Throttle twistgrip in fully closed
position
Clutch pulled
Once the new ride mode has
been activated, the selection
menu disappears from the dis-
play.
The mode selected in this way
is retained with the engine-
characteristic, ABS, DTC and
DDC adaptation settings even
after the ignition has been
switched off.
In SLICK mode, the current DTC
fine tuning 5 settings are also
shown.