Loading Boot 1 And Boot 2 And Firmware - Datamax I-Class Mark II Maintenance Manual

I-Class Mark II Maintenance Manual
2.5.1

Loading Boot 1 and Boot 2 and Firmware

1) Connect the printer to your PC using a serial cable.
2) Launch the NETira CT configuration utility, and query (connect) to the printer, (see the Operator's Manual
for more information on NETira CT).
It is recommended that the configuration be saved before downloading firmware, and restored

when finished. Be sure to check the box labeled "Include Sensor Calibration Data on Open"
when restoring the configuration.
3)
Go to the Tools>Upgrade>Firmware. Select the binary files (BIN files) for each of the Boot files.
4) Check the "Select and Download Boot 1 file:", "Select and Download Boot 2 file:" and "Erase System
and/or User Area" boxes and click send to initiate the download.
Be sure only that only one communication cable is connected to the printer before attempting

the firmware upgrade. Do not attempt to send any other data or perform operations via the
front panel when the firmware is downloading.

Always Check "Erase System and/or User Area" box unless otherwise instructed.
5)
Once the Boot Loader files have been loaded, the firmware version can now be updated using the
procedure outlined in section 2.5.
Adjustments and Maintenance
28