Datamax I-Class Mark II Maintenance Manual page 16

I-Class Mark II Maintenance Manual
Advanced Entry Calibration (continued)
Step Action
Press and hold the FEED button
R until at least one label has been
output.
Displayed Message
CALIBRATION COMPLETE
Followed by...
READY
12
Adjustments and Maintenance
Comment
The printer is ready for use.
 If the calibration attempt fails,
try desensitizing the sensor as
follows:
Re-enter the ADVANCED MENU.
Go to MEDIA SETTINGS /
SENSOR CALIBRATION /
ADVANCED ENTRY / TRAN (or
REFL) SENSOR GAIN and lower
the corresponding GAIN SETTING
by one.
Exit the menu and save your
changes. Test your media at the
new setting. If necessary, repeat
until a usable Gain Setting is
obtained.