General Operation Information; Power Switch; Before Your First Fire - Heatilator PT60 Owner's Manual

CAUTION! Tested and approved for wood pellets, shelled
fi eld corn, wheat and black oil sunfl ower seeds. Burning of
any other type of fuel voids your warranty.
Changing to Different Fuel Type
• Empty the hopper of the previous fuel
• Thoroughly vacuum hopper before fi lling with the new
fuel
• Select the appropriate setting on the FUEL SELECTION
screen on the thermostat wall control
The burn rate, BTU content and heat output will all vary
depending on the fuel selected.
Storage
• Wood pellets should be left in their original sealed bag
until using to prevent moisture absorption.
• Shelled corn, wheat or sunfl ower seeds should be stored
in a tight container to prevent it from absorbing moisture
from damp or wet fl oors.
• This will also prevent rodents from becoming a problem.
• Do not store any pellet fuel within the clearance
requirements or in an area that would hinder routine
cleaning and maintenance.
D. General Operating Information
Read and understand the Thermostat
Wall Control manual for detailed operating
instructions. The wall control is an intregal
part of how to operate this appliance.
1. Thermostat Wall Control - Automatic Setting
The appliance is like most modern furnaces; when the
thermostat wall control calls for heat, your appliance will
automatically light and deliver heat.
When the room is up to temperature and the wall control is
satisfi ed the appliance will shut down.
In the automatic setting the heat output level is controlled by
the wall control. Select "Automatic" on the AUTO/MANUAL
screen. Figure 9.1.
Automatic
Manual
Off
Figure 9.1
April 29, 2011
2. Thermostat Wall Control - Manual Setting
When you select "Manual" on the AUTO/MANUAL screen the
appliance will still automatically turn on and off according to
the temperature setting.
However, you will be able to manually control the heat output
levels. Adjust the heat output levels by using the HEAT
OUTPUT LEVEL screen. Figure 9.2.
Figure 9.2
3. Auto-Clean Firepot System
Your appliance is equipped with an automatic fi repot cleaning
system that will change the frequency of cleaning based on
the fuel being burned.
The auto-clean system will clean itself immediately on initial
plug in. If there is a power outage, as soon as power is
restored it will recycle and clean itself if there is no fi re in the
fi repot.
NOTE: User is responsible for removing the ash from the
ash drawer.
E. Power Switch
The power switch is located at the bottom right hand corner of
the fi replace. It turns the power on and off to the fi replace.
Before servicing the fi replace this power switch must be in
the off position. When the power switch is OFF there will be
no display on the wall control screen.

Power Switch

Figure 9.3
F. Before Your First Fire
• First, make sure your appliance has been properly installed
and that all safety requirements have been met.
• Pay particular attention to the fi re protection, venting and
thermostat wall control installation instructions.
• Double check that the ash pan, hopper and fi rebox are
empty and then close the fi rebox door.
NOTICE: The tip of thermocouple must be in contact with the
inside end of the thermocouple cover or missed ignitions can
occur.
7051-507
POINTE Pellet Fireplace
Medium
Power
Switch
= ON
I
0
= OFF
Page 9