Outside Air Installation - Heatilator PT60 Owner's Manual

I. Outside Air Kit Installation
Outside air is required on ALL installations. The Out-
side Air Kit must be ordered seperately.
CAUTION! Risk of Fire or Asphyxiation! Do not draw
outside combustion air from wall, fl oor or ceiling cavity, or
enclosed spaces such as an attic or garage.
• Do not place outside air inlet close to exhaust vents
or chimneys. Fumes or odors could be drawn into the
room.
• Locate outside air inlet to prevent blockage from
leaves, snow/ice, or other debris.
cause combustion air starvation.
Install Outside Air Kit
• Keep duct runs short and straight to minimize restriction.
• The outside air kit can be installed in three different
locations - the left or right side or from the back of the
fi replace. Figure 42.1 on page 42.
• Locate the air inlet in a clear area, preferably into prevailing
wind during the heating season. Figure 42.2 on page 42.
• Install as shown in Figure 43.1.
• The air duct may be run vertically.
April 29, 2011
Included in Kit: 2 wire ties, 1 collar assembly, 1 termina-
tion cap assembly, 1 trim ring, fasteners.
NOTE:
Tools Needed: Phillips Head screwdriver; wire cutters;
hole saw or jig saw.
1. Measure distance from fl oor to air vent opening in appli-
Blockages could
2. Use wire tie to secure fl ex pipe to collar assembly.
3. Slide trim ring over fl ex pipe and run pipe through wall.
4. Attach fl ex pipe (not supplied) to outside termination
5. Secure termination cap to outside surface.
6. Secure trim ring to the wall.
Figure 43.1 - Outside Air Installation
7051-507
POINTE Pellet Fireplace
3 Inch (75mm) Aluminum Flex Pipe Not Supplied.
ance and mark location on wall.
Use saw to cut opening in wall.
• Cut a 3-1/2 to 4 inches (89-102mm) opening on inside
wall.
* Cut a 4 to 4-1/2 inches (102-114mm) opening on out-
side of house.
cap with second wire tie.
Collar
Wire Ties
Trim Ring
Termination Cap
3 inch Aluminum Flex
Pipe (not included)
Page 43