Config System Menu Tree; Control Mode Configuration - Comtech EF Data Radyne RCS20 Installation And Operation Manual

RCS20 M:N Redundancy Switch
User Interfaces

4.3.2 CONFIG SYSTEM Menu Tree

4.3.2.1

CONTROL MODE CONFIGURATION

This screen allows the user to modify the control mode. The Control Mode may be one of the
following:
•
FT PANEL - Front Panel Control - Commands will only be accepted from the front
panel and keypad.
•
TERM - Remote Terminal Control - Commands will only be accepted through the RS-
232 terminal connection.
•
COMPUTER - Command Interface Control - Commands will only be accepted from the
RS-484 remote port connection.
Programming steps:
1. Press <FT PANEL>, <TERM>, or <COMPUTER> to select the desired control mode. The
mode will be selected immediately after pressing the appropriate key.
Key
S1 FT PANEL
S2
S3 COMPUTER
S4
Numeric
Keypad
CONTROL MODE CONFIGURATION
CONTROL MODE: FRONT PANEL
<FT PANEL>
Label Function
Press to select Front Panel Control.
TERM Press to select Remote Terminal Control.
Press to select Command Interface Control.
NEXT Press to cycle to the next screen.
Press <NEXT> to advance to next screen.
---
Press <CLR> to return to previous screen.
<TERM> <COMPUTER> NEXT
4–33
Rev. 14
MN-RCS20