Table of Contents
Advertisement
RCS20 M:N Redundancy Switch
Remote Operations
<1>
*Channel 0 Switch
Style
<2>
*Channel 0 Demod
Acquisition Delay
<1>
*Channel 0 Service
Mode
These 10 bytes (13 bytes as of release 4.0) repeat for channels 1 – 9 (uses 90
additional bytes) (uses 117 additional bytes as of release 4.0).
The Backup Delays and Demod Acquisition Delay applies only to channels 1 - 9 (the
four channel 0 bytes are ignored). If channel 9 is configured as backup 2, then the
four channel 0 Backup Delay bytes and the two Demod Acquisition Delay bytes are
ignored.
<1>
Switch Major Alarm
Mask
<1>
Switch Minor Alarm 1
Mask
<1>
Switch Minor Alarm 2
Mask
<1>
Maximum Number of
Backup Channels
<1>
Nonvolatile bytes per
Backup Channel
<1>
Backup 1 (Channel 0)
Configuration
<1>
Backup 1 (Channel 0)
Backup Mode
<1>
Backup 1 (Channel 0)
Force Manual
Modulator Backup
0 = Switch Mod and Demod separately, 1 = Switch Mod and Demod
together
0h-BB7h in tenths of a second; decimal point implied. For example, a
value of 100 means 10.0 sec.
0 = Normal, 1 = Service
Bit 0 = RAM/ROM fault
Bit 1 = No Backup for Faulted Prime
Bit 2 = Error During Backup
Bit 3 = Backup 1 Mod Error
Bit 4 = Backup 1 Demod Error
Bit 5 = Backup 2 Mod Error
Bit 6 = Backup 2 Demod Error
Bit 7 = Spare
(0 = mask, 1 = allow)
Bit 0 = Power Supply #1 Present
Bit 1 = Power Supply #1 Voltage
Bit 2 = Power Supply #2 Present
Bit 3 = Power Supply #2 Voltage
Bit 4 = Communications Error
Bit 5 = Faulted Prime Modem
Bit 6 = Faulted Backup Modem
Bit 7 = Modem Configuration Change
(0 = mask, 1 = allow)
Bit 0 = CDM Error
Bit 1 = Reserved (RCS10 only)
Bit 2 = Reserved (RCS10 only)
Bit 3 = Reserved (RCS10 only)
Bit 4 = Backup 1 Test Fault
Bit 5 = Backup 2 Test Fault
Bit 6 = Reserved (RCS10 only)
Bit 7 = Spare
(0 = Mask, 1 = Allow)
2 for RCS20
4 for RCS20
0 = Backup modem
0 = Manual, 1 = Automatic non-Revertive, 2 = Automatic Revertive
Channel number for manual backup (1 to 9) (ignored if in automatic
mode)
A–16
Rev. 14
MN-RCS20
Advertisement
Table of Contents
