Switch Major Alarms 2 - Comtech EF Data Radyne RCS20 Installation And Operation Manual

RCS20 M:N Redundancy Switch
User Interfaces
4.3.3.6 SWITCH MAJOR ALARMS 2
These screens display additional major alarms.
Masking alarms may cause undesirable modem performance
Key Label
S1
S2
S3 TOG MODE
S4 NEXT
Numeric
Keypad
SWITCH MAJOR ALARMS
BACKUP1 MOD ERROR
BACKUP1 DEMOD ERROR
BACKUP2 MOD ERROR
BACKUP2 DEMOD ERROR
Function
Press to move the blinking cursor up through the list of faults.
Press to move the blinking cursor down through the list of faults.
Used to toggle between YES (masked) and NO (not masked).
Press to cycle to the next screen.
Press <CLR> or <NEXT> to abort programming (no switch parameters
will be changed).
---
Press <ENT> to load the information on the screen into the switch
parameter table.
MASK
: PASS NO
: FAIL NO
: PASS NO
: FAIL NO
TOG MODE NEXT
4–66
Rev. 14
MN-RCS20