RCS20 M:N Redundancy Switch
Installation
2.2
Unpacking the Unit
There are no user-serviceable parts or configuration settings located inside
the RCS20, DDS20, or IFS20 Chassis. There is a potential shock hazard
internally at the power supply module. DO NOT open any of these Chassis
under any circumstances.
The RCS20 M:N Redundancy Switch was carefully packaged to avoid damage and should arrive
complete with the following items for proper installation:
•
RCS20 Redundancy Control Unit
•
IFS20 70/140, L-Band Tx or L-Band Rx-Tx
•
DDS20 Digital Data Switch, Ethernet Switch, ASI-M or ASI-D
•
2 ea. AC Power Cords
•
2 ea. Bank Control 15-Pin HD Sub-Cables
•
M:N Switch System Test Data Sheet
•
M:N Switch to Modem Cable(s) for Backup Modulator and Demodulator
•
Test I/O Mating Connector
•
Optional 1:N Switch to Modem, I/O and Coaxial Cables for Modems 1 – 9
•
Optional Modem bypass cable(s) for Modems 1 – 9
Any cables ordered in addition to those listed above may arrive separately.
2.2.1 Test Data Sheet
Each RCS20 M:N Redundancy Switch system is shipped with a Test Data Sheet. This report
contains information on the results of the Switch quality control testing. The report also includes
information pertaining to the system settings that were made at the factory. It is recommended
that the customer/user save this report for future reference.
2–2
Rev. 14
MN-RCS20