Rcu20 Back Panel Connectors; Slide-Out Redundant Power Supply/Switch Modules; Chassis Ground - Comtech EF Data Radyne RCS20 Installation And Operation Manual

RCS20 M:N Redundancy Switch
Electrical Interfaces
5.2

RCU20 Back Panel Connectors

5.2.1

Slide-Out Redundant Power Supply/Switch Modules

Dangerous AC voltages exist inside of the RCS20 when either one of the AC
Plug-in Switch Modules are enabled or plugged in. Do not remove cover
when AC power is applied. Remove power cord from AC modules if top
cover needs to be removed.
There are two Slide-Out Redundant Power Supply/Switch Modules located on the left and right
sides of the unit (as shown in Figure 5-2). Power applied to the port with the supplied power
cable is 100-240VAC, 50-60 Hz. Each Power Input Module provides an integrated Power On/Off
Rocker Switch. Power consumption for the unit is 1A.
5.2.2

Chassis Ground

A #10-32 threaded stud is located to the lower right of the left hand module for the chassis ground
connection.
Figure 5-2 RCS20 Connectors
5–2
Rev. 14
MN-RCS20