Roller-A - Oki OKIPAGE 10i Service Manual

Page: 129
Service Manual - OKIPAGE10i
Chapter E Multi-Purpose Feeder Maintenance
While only the removal procedure for roller-A is described here, the removal procedure for roller-B is
basically same. When removing roller-B, however, be careful not to deform the sensor plate.
(1) Remove the upper frame [ see 3.3.2 steps (1) through (3) ].
(2) Remove the separator assembly (see 3.3.2).
(3) Remove the OLEV-11-PCB (see 3.3.3).
(4) Remove the motor bracket (see 3.3.5).
(5) Remove the gear (1).
(6) Shift the roller-A (2) to the right, lift it on its left side and slide it out (the bearing (3) also comes off while
you are doing this, so be careful not to lose it).
Copyright 1997, Okidata, Division of OKI America, Inc. All rights reserved. See the OKIDATA Business
Partner Exchange (BPX) for any updates to this material. (http://bpx.okidata.com)