Oki OKIPAGE 10i Service Manual page 109

Category LCD status
message
Controller
errors
Copyright 1997, Okidata, Division of OKI America, Inc. All rights reserved. See the OKIDATA Business
Partner Exchange (BPX) for any updates to this material. (http://bpx.okidata.com)
Service Manual - OKIPAGE10i
Chapter 6 Troubleshooting Procedures
Problem or status
Code Error
(nn)
71 A failure occurred with the fuser
(timeout error etc).
72 A failure occurred with the fuser
(thermistor open error).
73 A failure occurred with the fuser
(thermistor short error).
74 SSIO Error
77 A toner sensor fault has
occurred when the TOTAL
DRUM COUNT is 30 or less.
80 I/F timeout occurred between
the main control board and the
operator panel.
81
90
91
F0
F1
Remedy
See Section 6.5.2-(4).
See Section 6.5.2-(4).
See Section 6.5.2-(4).
- Check the connection
between the main control
board and the power
supply/sensor board.
- Replace the main control
board or power
supply/sensor board.
- Check the installing of
image drum unit.
- Replace the power
supply/sensor board.
- Check the operator
panel for proper
connection.
- Replace the flexible
cable, operator panel or
main control board.
See Section 6.5.2-(5).
- Turn the power off, then
back on again.
- Replace the main control
board.
Note: When replaced the
main control board, be
sure to install the
EEPROM from the old
board to the new board.
Page: 72